Avtech DGC5645 Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avtech DGC5645. Avtech DGC5645 7 pages. Hd cctv 5mp ir bullet camera

Imprimer la page

 Model 2

Step 1: Loosen the screw as indicated below to move down the camera lens.

Then, fasten the camera to the ceiling or wall where you want to install.

1. loosen a bit

Step 2: Adjust the viewing angle of the camera as indicated below.

Step 3: Power on the camera and fine-tune the viewing angle.

For details, please refer to the section, "FOCAL LENGTH & FOCUS ADJUSTMENT".

CONNECTION

1. DC12V Input Terminal

Connect the power terminal of the camera to a DC 12V regulated power supply.

Note: Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power

tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this

unit.

2. Video Output Connector (VIDEO OUT)

Connect the camera video output to the video input of a DVR with 75Ω coaxial cable.

Note: To ensure the camera has sufficient protection against moisture, an extra waterproof

measure, such as by using an insulating tape, must be used to cover the power and video

connectors after connection.

2. Move down a bit

Vertical

Rotate

Horizontal