CPVan SM11R Manuel de référence rapide - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} CPVan SM11R. CPVan SM11R 6 pages. Interlinked smoke detector
Imprimer la page
room or other dead-air spaces.
Mounting Alarms
1. Twist off the mounting bracket from the alarm.
2. Put the bracket on the installation position and mark the
screw holes on the ceiling or the wall.
3. Drill two mounting holes in the marked place by an
electric drill (The diameter of the drill hole is 5mm) and
insert two plastic anchor plugs by hammer.
4. Screw the mounting bracket to the ceiling or the wall
(Refer to figure 3).
5. Attach the alarm to the mounting bracket and turn
clockwise to lock the alarm
WARNING: The installation instructions must be followed
strictly in case of any injury.
Test your Alarm
Test the unit to ensure proper operation by pressing the cover,
the alarm will sound if the unit are working well. If no sounds,
you can refer to "Trouble shooting" section for solution.
CAUTION:
1. DO NOT test your alarm using an open flame. This may
damage the smoke alarm, or ignite combustible materials
and start a structural fire.
2. DO NOT stand close to the alarm when the alarm is
sounding. Exposure at close range may be harmful to
your earning, so step away when testing.
3. Weekly Test: test this smoke alarm once a week.
LED Indicators
1. Normal status: Red LED Flashes once every 60 seconds.
2. Test status: Red LED flashes once every second.
3. Hush/Silence mode: Red LED flashes once every 8
seconds.
4. Low Battery status: Red LED flashes once every 60
seconds and 1 beep every 60 seconds.
Figure 3