DGSHAPE LC-3DPrint Box Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DGSHAPE LC-3DPrint Box. DGSHAPE LC-3DPrint Box 12 pages.

Imprimer la page

5.0 Operating

Please put the metal grid inside the chamber

and place a printed object on the metal grid.

Then operate according to the operating

instructions.

5.1

Starting mode

Press the power switch (green button)

on the right side.

When switching on the machine, the

version information message will

appear on the display.

After that the chamber temperature

will appear.

After the temperature the lamp-

burning hours will appear in the

display. Maximum time the lamps can

be used is 750 hours.

After 750 hours, replace all UV lamps.

When the UV lamp is irradiated with

the counter display "9999", the alarm

sounds. In that case, please press

on the front panel for 5 seconds. The

counter is reset and "0000" is

displayed.

After a while, the irradiation set time

at the last use is displayed on the

display.

5.2

Operation Mode

When the last operation time has

appeared on the display, the user can

choose a pre-set time by holding the

program button. Or the user can

increase or decrease the operation

time by pressing the increase or

decrease button.

User can start the machine by

pressing the start/stop button. The

time will count down and the dots will

be blinking. (By pressing the start/stop

button, the operation time will be

memorized automatically).

User can stop the machine by pressing

the start/stop button again.

After the operation time, the

message-"End" will be displayed

automatically. At the same time, the

machine beeps 9 times.

page 7 / 12