CPX PRO-MLS Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} CPX PRO-MLS. CPX PRO-MLS 11 pages.

[EN] PRO-MLS - Universal Heavy Duty Large Stand with Motorized Z Axis

the PRO-MLS stand and secure it by two screws. Connect the connector at the second end

of the cable to the CB-ZM-MLS control unit and secure it by the screws also.

The PRO-MLS stand is equipped with two limit switches. The limit switches are located

inside the motorized column part of the device. The upper limit switch position is fixed.

The vertical position of the lower limit switch is adjustable. If there is a microscopic stage

mounted to the PRO-MLS stand or specimens of a significant height are to be observed,

the lower limit switch position should be adjusted to prevent possible damage of specimens

or optics. In order to adjust the vertical position of lower limit switch proceed as follows:

1. Move the motorized carriage to the upper limit using the CB-ZM-MLS control unit.

2. Switch off the CB-ZM-MLS control unit and disconnect the cable from the PRO-MLS

stand.

3. Raise up the bottom part of the lower curtain which is fastened by a Velcro fastener.

(There is no big force necessary to do this).

4. Locate the limit switch printed circuit board at the left side of the inner space of the

motorized column.

5. Loosen up the M6 hexagonal screw which secures the position of the limit switch as

well as it works as a mechanical backstop. Do not screw out the screw, just loosen it

up.

6. Move the lower limit switch to the desired vertical position.

7. To fix the limit switch position tighten the M6 hexagonal screw.

8. Place the lower curtain to the original position.

There are four holes located at the rear side of the bedplate which are intended for grounding

purposes.

5. Limit Switches

6. Grounding