Dell Inspiron 1210 Manuel d'entretien - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dell Inspiron 1210. Dell Inspiron 1210 39 pages. Service manual
Également pour Dell Inspiron 1210 : Manuel de démarrage rapide (19 pages)
Imprimer la page
Back to Contents Page
Replacing the 2-in-1 Processor and Memory Board
Dell™ Inspiron™ 1210 Service Manual
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1. Follow the instructions in
Before You
2. Remove the palm rest. See
NOTICE:
When the 2-in-1 memory and processor board is not in the computer, store it in protective antistatic packaging (see "Protecting Against
Electrostatic Discharge" in the safety instructions that shipped with your computer).
NOTE:
The thermal pads may stick to the bottom of the palm rest. Remove the thermal pads from the bottom of the palm rest.
1
M2x4-mm screw (2)
3
tab in the connector slot
3. Remove the two thermal pads on the processor.
4. Place the thermal pads on the new 2-in-1 memory and processor board.
5. Remove the two M2x4-mm screws that secure the 2-in-1 memory and processor board.
6. Use your fingertips to carefully spread apart the securing clips on either side of 2-in-1 memory and processor board connector until the board pops up.
Begin.
Replacing the Palm
Rest.
2
thermal pads (2)
4
securing clips (2)