Dell Inspiron 1410 Manuel d'entretien - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dell Inspiron 1410. Dell Inspiron 1410 36 pages.

Imprimer la page

Back to Contents Page

Memory Module

Dell™ Inspiron™ 1410 Service Manual

Removing the Memory Module(s)

Replacing the Memory Module(s)

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as a connector on the back of the computer).

You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on the

memory supported by your computer. Install only memory modules that are intended for your computer.

NOTE:

Memory modules purchased from Dell are covered under your computer warranty.

Your computer has two user-accessible SODIMM sockets that can be accessed from the bottom of the computer.

NOTICE:

If you need to install memory modules in both connectors, first install a memory module in the connector located at the bottom of the

computer (DIMM 1) before you install a module in the connector directly above it (DIMM 2).

Removing the Memory Module(s)

NOTICE:

If a memory module is installed in the DIMM 2 connector, remove it prior to removing the memory module from the DIMM 1 connector. Failure to

do so could result in damaging both memory modules.

1. Follow the procedures in

Before You

2. Remove the module cover (see

NOTICE:

To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.

3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

4. Remove the module from the connector.

memory module connector

memory module

Replacing the Memory Module(s)

1. Align the notch in the module edge connector with the tab in the connector slot.

2. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If the module does not click into place,

remove the module and reinstall it.

NOTE:

If the memory module is not installed properly, the computer may not boot.

Begin.

Module

Cover).

securing clip (2)