Dell Inspiron 600m Manuel d'entretien - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dell Inspiron 600m. Dell Inspiron 600m 41 pages. Hard drive
Également pour Dell Inspiron 600m : Commencer ici (2 pages), Commencer ici (2 pages), Commencer ici (2 pages), Manuel de démarrage (2 pages), Manuel de l'utilisateur (34 pages), Manuel de configuration (2 pages), Pour commencer (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Media Base User's Manual (26 pages), Manuel d'entretien (40 pages), Manuel d'entretien (41 pages), Installation et configuration (38 pages), Démarrage rapide (2 pages), Démarrage rapide (2 pages), Démarrage rapide (2 pages), Configuration de l'ordinateur (2 pages), Manuel d'entretien (41 pages), Manuel d'entretien (4 pages)

Imprimer la page
Dell Inspiron 600m Manuel d'entretien
Back to Contents Page

Before You Begin

Dell™ Inspiron™ 600m Service Manual
  Preparing to Work Inside the Computer
  Recommended Tools
  Computer Orientation
  Screw Identification

Preparing to Work Inside the Computer

 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow applicable instructions in safety instructions in the Owner's Manual that came with the computer.
 
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.
 
CAUTION:
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal
mounting bracket. Hold a component such as a microprocessor by its edges, not by its pins.
 
NOTICE:
To avoid damaging the computer, perform the following steps before you begin working inside the computer.
1.  Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2.  Save any work in progress and exit all open programs.
3.  Turn off the computer and all attached devices.
 
NOTE:
Ensure that the computer is off and not in a power management mode. If you cannot shut down the computer using the computer operating
system, press and hold the power button for 4 seconds.
4.  If the computer is connected to a docking station, undock it.
5.  Disconnect the computer from the electrical outlet.
6.  To avoid possible damage to the system board, wait 10 to 20 seconds and then disconnect any attached devices.
7.  Disconnect all other external cables from the computer.
8.  Remove any installed PC Cards from the PC Card slot.
9.  Close the display and turn the computer upside down on a flat work surface.
 
NOTICE:
To avoid damaging the system board, you must remove the main battery before you service the computer.
10.  Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the bay.
 
11.  Remove any installed
memory
12.  Remove the
hard
drive.
modules,
Mini PCI
cards, and modules, including a second battery if one is installed.