Dell Inspiron 600m Manuel d'entretien - Page 35

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dell Inspiron 600m. Dell Inspiron 600m 41 pages. Hard drive
Également pour Dell Inspiron 600m : Commencer ici (2 pages), Commencer ici (2 pages), Commencer ici (2 pages), Manuel de démarrage (2 pages), Manuel de l'utilisateur (34 pages), Manuel de configuration (2 pages), Pour commencer (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Manuel d'entretien (41 pages), Media Base User's Manual (26 pages), Manuel d'entretien (40 pages), Installation et configuration (38 pages), Démarrage rapide (2 pages), Démarrage rapide (2 pages), Démarrage rapide (2 pages), Configuration de l'ordinateur (2 pages), Manuel d'entretien (41 pages), Manuel d'entretien (4 pages)

Imprimer la page
Dell Inspiron 600m Manuel d'entretien
Back to Contents Page
Microprocessor Thermal-Cooling Assembly
Dell™ Inspiron™ 500m Service Manual
Removing the Microprocessor Thermal-Cooling Assembly
 
CAUTION:
Before performing the following procedures, read the safety instructions in your Owner's Manual.
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
 
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
1.  Follow the instructions in
"Preparing to Work Inside the
2.  Remove the keyboard.
 
NOTE:
You can remove the microprocessor thermal-cooling assembly with the fan attached.
3.  Loosen in consecutive order the four captive screws, labeled "1" through "4," that secure the microprocessor thermal-cooling assembly to the system
board.
 
 
1 microprocessor thermal-
cooling assembly
2 captive screws (4)
4.  Rotate the microprocessor thermal-cooling assembly up toward the side of the computer and away from the system board.
Installing the Microprocessor Thermal-Cooling Assembly
1.  Place the left side of the microprocessor thermal-cooling assembly under the palm rest and rotate the assembly onto the system board.
2.  Tighten the four captive screws, labeled "1" through "4," in consecutive order.
Back to Contents Page
 
Computer."