Avtech RMA-FS2-SEN Manuel

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Avtech RMA-FS2-SEN. Avtech RMA-FS2-SEN 4 pages. Flood sensor - spot

AVTECH

AVTECH's Flood Sensor - Spot monitors the

presence/absence of liquid on a flat surface.

When liquid collects underneath the blue

housing, it bridges the 2 adjustable-height

contacts and trips the sensor. The contacts,

which are 1" apart, arrive 1/32" off the ground,

and adjust individually from 0" to 1/8" high.

Self-adhesive feet on the bottom of the housing

allow you to fasten the sensor to trouble-spots

and also provide a gap to admit water to the

contacts.

Flood Sensor - Spot Package Contents

•

One (1) Flood Sensor - Spot with 25' low-voltage 2-wire cable attached

•

One (1) 9V alkaline battery

Flood Sensor - Spot

Housing

Install Your Flood Sensor - Spot

Do not use this sensor in hazardous (classified) locations or life safety applications.

Step 1: Adjust the height of the contacts if necessary.

You may leave the contacts at the factory-adjusted height of 1/32" away from

the floor, or adjust them between 0" and 1/8" high. To simulate the distance

to the floor, rest a straight-edge on the feet closest to the contacts while you

adjust them.

•

Tighten the contacts clockwise to raise them farther away from the floor.

•

Loosen the contacts counter-clockwise to lower them closer to the floor.

While you may lower the contacts flush to the floor (0" high), doing so

increases the chance of a false alarm—mere dampness or a film of dirt could

bridge the contacts. Metal, too, forms a complete circuit, so if you place the

unit on a metal surface, be sure to maintain a gap under the contacts.

Flood Sensor - Spot

Contacts

Foot

Liquid

Temperature & Environment Monitoring... Made Easy!

0" to 1/8" from surface

Foot

Surface