Craden DP9 Manuel du service d'assistance - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel du service d'assistance pour {nom_de_la_catégorie} Craden DP9. Craden DP9 19 pages. Transaction printers
Également pour Craden DP9 : Manuel technique (8 pages), Manuel d'installation (2 pages), Manuel de l'utilisateur (18 pages)

Imprimer la page

ERROR MESSAGES

Error messages are displayed when unexpected events occur.

Cover Open

If the printer cabinet is opened, "cover open" is displayed and printing is disabled. Printing will

resume 3 seconds after the cover is closed.

Page Overflow

If the printer is commanded to move past the last printable line on a document, it will eject the

document and display "PAGE OVERFLOW INSERT NEXT PAGE". Printing will resume when

another document is inserted.

Carriage Fault

This message will be displayed if the carriage could not move to the left margin and is probably

caused by a jammed ribbon cartridge, a dirty gap wheel or a left home sensor that is not working.

Check if the ribbon is installed properly and the cartridge knob can be rotated to advance the

ribbon. Initiate a service call if the condition persists.

Document Jam (see page 10)

In the event that a document becomes jammed in the printer, printing will stop and "DOCUMENT

JAM" will be displayed. Turn the printer off. Clear the jam by opening the cabinet, raising the

carriage with the carriage lifter ring and then turning the rollers by hand to clear the document.

When pulling the document out of the printer, pull straight out. Do not pull up and out as there is

the possibility of moving or damaging a document sensor. Be sure to remove all bits of paper as

they can block sensor operation.

Clear Eject Jam

If "CLEAR EJECT JAM" is displayed and a document is in the printer, press the CLEAR key and

EJECT again. One of the sensors may have not detected the document.

At power up or when all document sensors do not uncover, "CLEAR EJECT JAM" will be

displayed. Assure no document is covering the sensors and the sensors are clean. Turn power

off, open the cabinet and raise the lifter ring (see page 11) before manually removing a jammed

document. If no document is in the printer, the condition may be cleared by pressing the ENTER

key while powering the printer on. If the condition will not clear there may be a sensor failure.

Initiate a service call.

Narrow Document

Not an error message. When documents less than 2.4" wide are inserted and the middle sensor

does not "see" a document, "NARROW DOCUMENT" is displayed and the operator can press

ENTER to proceed or EJECT to abort.