Dell Vostro 1450 Manuel d'entretien - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dell Vostro 1450. Dell Vostro 1450 48 pages. Document
Également pour Dell Vostro 1450 : Informations sur l'installation et les caractéristiques (9 pages), Manuel de démarrage rapide (2 pages), Manuel d'entretien (48 pages)

Imprimer la page

Back to Contents Page

Wireless Mini-Cards

Removing the Mini-Card

Replacing the Mini-Card

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

CAUTION:

To help prevent damage to the system board, remove the main battery (see

computer.

CAUTION:

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™

is not covered by your warranty.

NOTE:

Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.

If you ordered a wireless Mini-Card with your computer, the card is already installed.

Your computer supports two Mini-Card slots:

one full Mini-Card slot – for WWAN

one half Mini-Card slot – for WLAN

The types of Mini-Cards supported are:

Wireless Local Area Network (WLAN) — Half Mini-Card

Mobile broadband or Wireless Wide Area Network (WWAN) — Full Mini-Card

NOTE:

Your computer can only support one full Mini-Card and one half Mini-Card at a time.

NOTE:

The WLAN slot supports a half Mini-Card.

NOTE:

Depending on the configuration of the computer when it was sold, one or more of the Mini-Card slots may not have Mini-Cards installed in them.

Removing the Mini-Card

1. Follow the instructions in

Before You

2. Remove the base cover (see

CAUTION:

When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking

tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep

them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented

and aligned.

3. Disconnect the antenna cables from the Mini-Card.

1 Mini-Card

2 screws (2)

Begin.

Removing the Base

Cover).

Removing the

Battery) before working inside the