Video screen options
Table 22. Video
Option
Primary Display
Security
Table 23. Security
Option
Admin Password
System Password
Internal HDD-0 Password
Password Configuration
Password Bypass
Password Change
UEFI Capsule Firmware Updates
TPM 2.0 Security
28
System setup
Description
Allows you to select the primary display when multiple controllers are available in the system.
•
Auto (default)
•
Intel HD Graphics
NOTE:
If you do not select Auto, the on-board graphics device will be present and
enabled.
Description
Allows you to set, change, and delete the admin password.
Allows you to set, change, and delete the system password.
Allows you to set, change, and delete the computer's internal hard drive password.
Allows you to control the minimum and maximum number of characters that are allowed for an
administrative password and the system password. The range of characters is between 4 and 32.
This option lets you bypass the System (Boot) Password and the internal hard drive password
prompts during a system restart.
•
Disabled — Always prompt for the system and internal HDD password when they are set. This
option is disabled by default.
•
Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE:
The system will always prompt for the system and internal HDD passwords
when powered on from the off state (a cold boot). Also, the system will always prompt
for passwords on any module bay HDDs that may be present.
This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes - This option is enabled by default.
This option controls whether this system allows BIOS updates via UEFI capsule update packages.
This option is selected by default. Disabling this option will block BIOS updates from services such as
Microsoft Windows Update and Linux Vendor Firmware Service (LVFS).
Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating
system.
•
TPM On (default)
•
Clear
•
PPI Bypass for Enable Commands
•
PPI Bypass for Disable Commands
•
PPI Bypass for Clear Commands
•
Attestation Enable (default)
•
Key Storage Enable (default)
•
SHA-256 (default)
Choose any one option:
•
Disabled
•
Enabled (default)
Imprimer la page