Dell D28M004 Manuel de configuration et de spécifications - Page 32
Parcourez en ligne ou téléchargez le pdf Manuel de configuration et de spécifications pour {nom_de_la_catégorie} Dell D28M004. Dell D28M004 38 pages.
Imprimer la page
Table 30. POST Behavior (continued)
Option
Extend BIOS POST Time
Full Screen Logo
Warnings and Errors
Manageability
Table 31. Manageability
Option
Intel AMT Capability
USB provision
MEBx Hotkey
Virtualization support
Table 32. Virtualization Support
Option
Virtualization
VT for Direct I/O
32
System setup
Description
● Minimal — The system boots quickly, unless the BIOS has been updated, memory
changed, or the previous POST did not complete.
● Thorough — The system does not skip any steps in the boot process.
● Auto — This allows the operating system to control this setting (this works only when
the operating system supports Simple Boot Flag).
This option is set to Thorough by default.
This option creates an additional pre-boot delay.
● 0 seconds (default)
● 5 seconds
● 10 seconds
This option will display full screen logo if your image match screen resolution. The option
Enable Full Screen Logo is not set by default.
This option causes the boot process to only pause when warning or errors are detected.
Choose any one of the option:
● Prompt on Warnings and Errors - default
● Continue on Warnings
● Continue on Warnings and Errors
Description
This option enables you to enable or disable Intel AMT capability. The options are:
● Disabled
● Enabled—enabled by default
● Restrict MEBx Access
This option is disabled by default.
This option is enabled by default.
Description
This option specifies whether a Virtual Machine Monitor (VMM) can utilize the additional
hardware capabilities provided by the Intel Virtualization technology.
● Enable Intel Virtualization Technology
This option is set by default.
Enables or disables the Virtual Machine Monitor (VMM) from utilizing the additional hardware
capabilities provided by the Intel Virtualization technology for direct I/O.
● Enable VT for Direct I/O
This option is set by default.