Allied Telesis AT-MWS600AP Manuel d'installation rapide

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allied Telesis AT-MWS600AP. Allied Telesis AT-MWS600AP 2 pages. Simultaneous dual band access point

Imprimer la page
Quick Installation Guide
AT-MWS600AP
Simultaneous Dual Band Access Point
Installation Guide
This document contains an abbreviated version of the installation instructions for the
MWS Series Access Points Installation Guide. For the complete installation instructions
including the installation safety statements, see the product documentation on the Allied
Telesis web site at www.alliedtelesis.com.
Safety and Electromagnetic Emissions Certificates
For Safety and Electromagnetic Emissions certificates, refer to MWS Series Access
Point Installation Guide.
European Union Restriction of the Use of Certain Hazardous
Substances (RoHS) in Electrical and Electronic Equipment
This Allied Telesis RoHS-compliant product conforms to the European Union Restriction
of the Use of Certain Hazardous Substances (RoHS) in Electrical and Electronic
Equipment. Allied Telesis ensures RoHS conformance by requiring supplier Declarations
of Conformity, monitoring incoming materials, and maintaining manufacturing process
controls.
Europe - EU Declaration of Conformity
This device complies with Directive 2014/53/EU issued by the Commission of the
European Community. For more information, refer to MWS Series Access Point
Installation Guide.
Note
Note
Contact Allied Telesis for the EU conformity statement. To contact Allied Telesis,
visit our web site at www.alliedtelesis.com.
Redundancy Power Supply
The access point is equipped with one PoE+ capable LAN port and a DC power supply
jack. If the power supply unit on the access point fails or is not connected, the access
point draws its power through the PoE+ LAN port.
Note
Note
The AC adapter is not included in the shipping box. You must purchase the
AT-MWS0091 AC adapter separately.
Copyright  2017 Allied Telesis, Inc.
All rights reserved. No part of this publication may be reproduced without prior written
permission from Allied Telesis, Inc.
*613-002488 Rev A*
613-002488 Rev. A
Installation Orientations
The access point can be installed on a table, ceiling, or wall.
Correct Table Installation
The access point must be installed on the wall in the following orientations. In other
orientations, the access point cannot have a proper airflow.
LEDs
LED
State
Power
Orange
The access point is powered ON and operating
normally.
Off
The access point is not receiving power.
LAN
Blue
A valid link is established on the port.
Blinking Blue
Data is being transmitted/received.
Off
No link is established.
Blue
The 2.4GHz WiFi interface is enabled.
Blinking Blue
Data is being transmitted/received at the 2.4GHz
2.4GHz Wi-Fi
frequency band.
Off
The 2.4GHz Wi-Fi interface is disabled.
Green
The 5GHz WiFi interface is enabled.
Blinking
Data is being transmitted/received at the 5 GHz
5GHz Wi-Fi
Green
frequency band.
Off
The 5GHz Wi-Fi interface is disabled.
Nor supported.
1
Components in the Shipping Box
Correct Ceiling Installation
Mounting
4351
Base Kit
4352
Description
Rail Clip Kit
2
Name and Description
Component
1 x Mounting Base
2 x Screw for the mounting base
(M2.6 9.8mm)
2 x Narrow rail clip
2 x Wide rail clip
2 x Spacer
2 x Short screw to attch a rail clip
without the spacer or attach to
the access point directly
2 x Long screw to attach a rail
clip with the spacer
4350
3