Allied Telesis 86241-02 Note de mise à jour - Page 4

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} Allied Telesis 86241-02. Allied Telesis 86241-02 12 pages. Patch for rapier switches and ar800 series modular switching routers

Imprimer la page

PCR: 02299

Module: VRRP

If a packet with a destination IP address equal to a VRRP IP address was

received when the router didn't own the IP address, (because it didn't have

an interface with that IP address) the router incorrectly tried to forward the

packet and send an ICMP "redirect" message to the source. Now, if such a

packet is received, it will be discarded and an ICMP "host unreachable"

message will be sent to the source.

PCR: 02301

Module: IPG

If a DNS relay agent was configured with overlapping subnets, sometimes

the DNS server response was returned to the client with a source IP address

of an interface on the relay agent that was different from the interface the

request was received on. This issue has been resolved.

PCR: 02302

Module: IPv6

The default router lifetime value has been corrected. Also, the SET IPV6

INTERFACE command now updates valid and preferred lifetimes correctly.

PCR: 02303

Module: INSTALL

When enabling or disabling feature licences, a message will now be

generated with a warning that changes to feature licences may not take

effect until after a reboot.

PCR: 02304

Module: VRRP

VRRP used the wrong source IP address in ICMP redirects. RFC 2338 states

that the source IP address of ICMP redirects should be the IP address that

the end host used when making its next hop routing decision. In the case of

a packet sent to a VRRP virtual MAC address, this is the primary VRRP IP

address associated with the MAC address, provided such a VR exists and is

in the master state. This issue has been resolved.

PCR: 02309

Module: STP

On models except Rapier i Series Switches, the ENABLE STP DEBUG PORT

command did not work correctly. This issue has been resolved.

PCR: 02311

Module: SWI

It was possible to set the trunk speed to 10/100M, even if the port within the

trunk was not capable of this speed. This issue has been resolved.

PCR: 02313

Module: IPV6

The SHOW IPV6 INTERFACE command now shows the address lifetime

aging status that is determined by the DECREMENT parameter in the ADD

IPV6 INTERFACE command. The default valid and preferred address

lifetimes have been changed to 30 days and 7 days respectively.

PCR: 02320

Module: IPV6

The interface address preferred lifetime was not operating correctly. This

issue has been resolved.

Patch Release Note

Network affecting: No

Patch 86241-02 for Software Release 2.4.1

C613-10340-00 REV B