Dell DR4000 Restore Manager Notes de mise à jour - Page 5
Parcourez en ligne ou téléchargez le pdf Notes de mise à jour pour {nom_de_la_catégorie} Dell DR4000 Restore Manager. Dell DR4000 Restore Manager 16 pages. Dell dr series system system interoperability guide release 2.0.0.0
Également pour Dell DR4000 Restore Manager : Manuel d'introduction (6 pages), Mise en place (1 pages), Note de mise à jour (16 pages), Manuel (12 pages)
Imprimer la page
Table 1. Known Best Practices Issues and Workarounds for Release 1.0
Issue
Description
8878
The DR4000 system encountered
"Manual
an issue during the calibration of
Intervention
the super capacitor that caused the
Required"
"Manual Intervention Required"
message
system state message to display.
displayed.
8897
Currently, the DR4000 system can
DR4000 and
encounter some low-level system
iDRAC
reboot management coordination
reboot
issues when the reboot is initiated
mismatch.
using iDRAC.
DR4000 System Release Notes, Release 1.0
Workaround/Solution
After this message displays, allow
the DR4000 system 15-30
minutes before attempting a cold
reboot of the system. The
DR4000 system should start up
with all services running
normally.
Initiate the reboot of the DR4000
system using either of the two
following choices:
• DR4000 system CLI command
(system --reboot)
• DR4000 system GUI command
(System Configuration
)
Reboot
When the reboot is initiated using
system CLI or GUI commands,
the data contents are properly and
fully flushed to disk, before the
system is shut down. Failure to
follow this practice will cause the
DR4000 system to start filesystem
recovery during the boot process
(and lengthen the time required
for system reboot to complete).
(continued)
3