Dell DX6004S Manuel de l'utilisateur - Page 36

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dell DX6004S. Dell DX6004S 46 pages. Document
Également pour Dell DX6004S : Manuel complémentaire (4 pages), Manuel d'installation et de configuration (43 pages), Manuel d'installation et de configuration (35 pages), Manuel de démarrage (28 pages), Avis (28 pages), Avis (20 pages), Vue d'ensemble (19 pages), Manuel de configuration (9 pages), Manuel de configuration (9 pages), Note de mise à jour (8 pages), Manuel de configuration (7 pages), Note de mise à jour (6 pages), Note de mise à jour (5 pages), Notes de mise à jour (5 pages), Manuel de démarrage (49 pages)

5 Create a 10 GB restore partition of the file system type physical volume

(LVM) within the sda and click OK.

6 Select /dev/sdb1 from the Device list and click Edit.

7 Select Format partition as ext3.

8 In the Mount Point field, enter /u01 and click OK.

The /u01 mount point occupies the entire space of the sdb.

9 Click Next.

The /u01 mount path can also be configured after installing the operating

system. To configure the mount path after installing the operating system:

1 Identify the disk to be formatted. To identify the disk to be formatted, run

the following command:

fdisk -l | grep '^Disk'

2 Create a partition on the /dev/sdb block device using parted:

parted /dev/sdb

3 Create a gpt label on the block device:

(parted) mklabel

Yes/No: Yes

New disk label type? [gpt]? gpt

4 Create a partition that consumes the entire available space on /dev/sdb:

(parted) mkpart primary ext3 0 -1

Once the partition is created, exit using the following command:

(parted) quit

5 Create a file system on the formatted partition table. For example, run the

following command:

mkfs.ext3 -m1 /dev/sdb1

6 Create the /u01 directory in root directory and mount the file system to

the /u01 directory. For example, run the following command:

mkdir /u01

mount /dev/sdb1 /u01

Disaster Recovery