Dell Force10 S25-01-GE-24P Manuel - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell Force10 S25-01-GE-24P. Dell Force10 S25-01-GE-24P 48 pages. Installing the s25p system
Également pour Dell Force10 S25-01-GE-24P : Manuel de configuration (8 pages)

Imprimer la page

1. Accessing the Console Port

Power

The S25P comes standard with two AC power supplies acting in load-sharing mode; see

page

9. Use the power cords shipped with the S25P to connect it to AC power outlets, ideally on separate

circuits. Several versions of the power cord are available, based on country requirements.

The power supply cord is used as the main disconnect device; ensure that the socket-outlet is

Caution:

located/installed near the equipment and is easily accessible.

S25P-DC

As shown below, the right side (as you face the back of the unit) of the S25P-DC contains two terminal

blocks for two DC power supply inputs acting in load-sharing mode. The left terminal block, as you face

the back, corresponds to the DC2 status LED on the front left of the switch; DC1 is on the right.

Figure 3 The S50N-DC Rear View

10-Gigabit Modules or Stacking Modules (optional).

Optical ports numbered from left to right.

Figure 4 The S50N-DC Rear View

For details on connecting to a power source, see

Storing Components

If you do not install your system and components immediately, Force10 Networks recommends that you

properly store the S25P and all optional components until you are ready to install them. Follow these

storage guidelines:

•

Storage temperature should remain constant, in the range from -40° to 158° F (-40°C to 70° C).

•

Storage humidity should be within 10 to 90% (relative humidity), non-condensing

•

Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.

•

Store in a dust-free environment.

Installing the S25P System

Ethernet Port Numbers

25 to 28, Right to Left

Label (Part #, Serial #, MAC Address, Bar Code, FRU #)

Ground Connector

Supplying Power on page

Figure 2 on

DC2

-48V

RTN

DC1

27.