Dell Force10 S25-01-GE-24P Manuel - Page 32
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell Force10 S25-01-GE-24P. Dell Force10 S25-01-GE-24P 48 pages. Installing the s25p system
Également pour Dell Force10 S25-01-GE-24P : Manuel de configuration (8 pages)
Imprimer la page
Installing XFPs
To install an XFP into one of the two ports in the optional 10GbE optical module (see
Modules (10-Gigabit or Stacking) on page
Warning:
Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear
an ESD-preventive wrist or heel ground strap when handling the S25P and its components.
Warning:
Do not look directly into any optical port. Failure to follow this warning could result in physical
harm. For details, see
Step
Task
Position the XFP so it is in the upright position. (The XFP has a key that prevents it from being inserted
1
incorrectly.)
2
Insert the XFP into the port until it gently snaps into place.
Figure 20 Rear View of S25P with XFP
Caution:
You can insert and connect SFP and XFP transceivers while the switch is operating. You can also
disconnect and remove the transceivers while the switch is operating. However, inserting or removing the
XFP module is not supported; it can crash or lock up the switch, requiring a reboot.
Note: The CX4 module does not use transceivers. However, you can use a CX4 cable with an XFP port by
inserting a CX4 XFP converter (catalog name GP- XFP-1CX4) into the slot. An XFP port does not support
the use of the
cx4-cable-length
Stacking) on page 17
For enabling ports with FTOS, see the FTOS Configuration Guide.
With SFTOS, see the SFTOS Configuration Guide or the S50V and S50N Quick Reference.
32
17) on the back of the switch, follow the procedure below:
Information Symbols and Warnings on page
command. For details, see
in
Chapter 3, Installing the
5.
Inserting Optional Modules (10-Gigabit or
S25P.
Inserting Optional
Installing Ports