Dell PowerConnect M8428-k Manuel - Page 23

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell PowerConnect M8428-k. Dell PowerConnect M8428-k 25 pages. Dell poweredge m710 and m710hd - system memory update
Également pour Dell PowerConnect M8428-k : Manuel de mise à jour (32 pages), Notes de mise à jour (27 pages), Manuel de l'utilisateur (23 pages), Manuel de mise à jour (1 pages)

Imprimer la page

After loading the .pfw file, both the software and firmware will be programmed onto the 10GbE

PTM.

The update process takes a few minutes.

Note:

At the end of this process, the following message will be displayed at the prompt:

# Received update image successfully. Changes will take effect after

next reboot.

Exit the 10GbE PTM CLI to the CMC command line. Run:

Step 6.

# exit

Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command line type

Step 7.

the following command:

$ racadm chassisaction -m switch-<n> powercycle

Wait for 20 seconds, and then connect to the 10GbE PTM. Run:

Step 8.

$ connect switch-<n>

You will be able to view the progress of the SW update.

At the end of a successful SW update process, the following message will be displayed:

Step 9.

FW updated successfully!

Welcome to the Dell 10GbE PTM Management Console firmware X.X.XXX-<date

stamp>

Step 10.

# login admin

To confirm that all PhyX® chips have the same firmware version, run the command:

Step 11.

& show image ver

Software image version: X.X.XXX-<date stamp>

Component #1 FW version: Y.Y.YYY

Component #2 FW version: Y.Y.YYY

Component #3 FW version: Y.Y.YYY

Rev 1.00