Dell PowerEdge 100 Manuel d'installation - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 100. Dell PowerEdge 100 32 pages. Dell poweredge 350 servers: installation guide
Imprimer la page
support.dell.com
Before You Begin
Before you begin installing your system in the rack, carefully read "Safety Instruc-
tions," found earlier in this guide.
NOTICE: This rack kit is intended to be installed in a Dell rack by trained
service technicians. If you install the kit in any other rack, be sure that the
rack meets the specifications of American National Standards Institute
(ANSI)/Electronic Industries Association (EIA) standard ANSI/EIA-310-D-92,
International Electrotechnical Commission (IEC) 297, and Deutsche Indus-
trie Norm (DIN) 41494. One rack kit is required for each Dell server,
storage system, or appliance that is installed in a rack.
Recommended Tools and Supplies
You need the following tools and supplies to install the system in a four-post rack
cabinet:
•
A #2 Phillips screwdriver
•
A flat-blade screwdriver
•
Masking tape or a felt-tip pen, for use in marking the mounting holes to be used
Installing the Rack Kit
NOTES: If you purchased a Dell rack along with your system, the slide assemblies
may be preinstalled in the rack.
For instructions on installing the system itself, see "Installing the System in the Four-
Post Rack" found later in this guide.
To install the slide assemblies in the rack, perform the following steps:
1.
Remove the rack's front and back doors.
2.
Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
Rack Installation Guide
1-13