Dell PowerEdge 2400 Manuel d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 2400. Dell PowerEdge 2400 20 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 2400 : Manuel d'installation (8 pages), Instructions pour l'installation du rack (32 pages), Mise à jour (2 pages), Manuel d'activation (8 pages), Manuel d'installation (8 pages), Manuel de mise à jour (2 pages), Manuel (15 pages)

(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm

1-4

Microprocessor Upgrade Installation Guide

,QVWDOOLQJ DQ 8SJUDGH 0LFURSURFHVVRU LQ

3RZHU(GJH 6\VWHPV

This section provides instructions for:

Removing the cooling shroud, single-edge contact (SEC) cartridge, and heat sink

Installing the new SEC cartridge and heat sink and replacing the cooling shroud

Reassembling and checking the system

5HPRYLQJ WKH &RROLQJ 6KURXG 6(& &DUWULGJH DQG

+HDW 6LQN

Turn off the system, including any attached peripherals, and disconnect the power

cable from the electrical outlet.

Remove the right-side system cover and bezel.

See your system Installation and Troubleshooting Guide for specific instructions,

if needed.

Remove the cooling shroud as follows:

Unscrew and remove the two retention pins (see Figure 1-1).

Remove the shroud by lifting the end of the shroud closest to the micropro-

cessor(s) until the opposite end of the shroud disengages from the cooling

fan on the system's back panel (see Figure 1-1).

DELL CONFIDENTIAL - Preliminary

9/11/00