Dell PowerEdge 2400 Instructions pour l'installation du rack - Page 20

Parcourez en ligne ou téléchargez le pdf Instructions pour l'installation du rack pour {nom_de_la_catégorie} Dell PowerEdge 2400. Dell PowerEdge 2400 32 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 2400 : Manuel d'installation (20 pages), Manuel d'installation (8 pages), Mise à jour (2 pages), Manuel d'activation (8 pages), Manuel d'installation (8 pages), Manuel de mise à jour (2 pages), Manuel (15 pages)

Imprimer la page
Dell PowerEdge 2400 Instructions pour l'installation du rack
1-8
Dell PowerEdge 2400 Systems Rack Installation Guide
1 unit (1.75 inches)

Figure 1-6. One Rack Unit

For more information, see the Dell Rack Advisor software available on the Dell Web
site at http://www.dell.com.
WARNING: If you are installing more than one computer, install the slide
assemblies so that the first computer is installed in the lowest available
position in the rack.
To install the slide assemblies in the rack, perform the following steps:
1.
Place the front of the template over the front of the front rack rails (see
Figure 1-7).
Position the bottom of the template in line with the desired bottom position of
the computer chassis.
2.
Mark the upper- and lower-mounting positions for the slide brackets.
3.
Turn over the template and place the back of the template over the front side of
the back rack rails in the same position as you placed it on the front rack rail.
4.
Mark the upper- and lower-mounting positions for the slide brackets as shown on
the template.
After determining where to install the PowerEdge system, mark the rack's front and
back vertical rails with a felt-tip marker or masking tape where the system's lower
edge will be located.