Dell PowerEdge 2450 Manuel d'installation du matériel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Dell PowerEdge 2450. Dell PowerEdge 2450 32 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 2450 : Manuel d'installation (26 pages), Manuel d'installation (32 pages), Manuel d'installation (20 pages), Information Update (12 pages), Manuel complémentaire (30 pages), Manuel du logiciel (10 pages), Manuel d'installation (8 pages), Manuel (15 pages)

1-4

Dell PowerEdge 2450 Systems — Installing a Fifth SCSI Hard-Disk Drive

7 .

Slide the peripheral bay toward the back of the system approximately 2.5 cm

(one inch); then lift the peripheral bay upwards and set it aside.

If the peripheral bay is empty, remove the rectangular plastic insert from the front

of the system chassis.

From the inside of the chassis, push outwards on the center of the plastic insert

to release the insert from the chassis.

If a tape drive or other drive is installed in the peripheral bay, release the drive by

pressing the front of each drive rail, and slide the drive out of the bay.

10. Slide the hard-disk drive cage into the peripheral bay until the rails snap into place

(see Figure 1-3).

11. Lower the peripheral bay back into the chassis; then slide the bay forward into

position.

Be careful to avoid trapping power or interface cables underneath the peripheral

bay when you reinstall it.

12. Secure the peripheral bay by tightening the thumbscrew at the back corner of the

cage.

13. Connect the SCSI interface cable (see Figure 1-1) to the SCSI cable connector on

the fifth-drive backplane board at the back of the hard-disk drive cage (see

Figure 1-4).

SCSI cable connector

interface cable connector

Figure 1-4. Connectors on the Fifth-Drive Backplane Board

14. Connect one end of the ribbon-style interface cable provided in your drive

upgrade kit to the 10-pin interface cable connector on the fifth-drive board (see

Figure 4).

15. Attach the other end of the ribbon-style interface cable to connector DRIVE5 on

the main SCSI backplane board (see Figure 5).

power connector