Dell PowerEdge 2500 Manuel d'installation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 2500. Dell PowerEdge 2500 10 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 2500 : Manuel de configuration (10 pages), Manuel d'activation (24 pages), Manuel de rattachement (10 pages), Manuel (15 pages)
Imprimer la page
Align the tabs on side of the peripheral bay with the locking slots in the chassis and
3
slide the peripheral bay forward.
Tighten the thumbscrew securing the peripheral bay to the chassis (see Figure 1-1).
4
2
Installing the
I
C Extension
2
Disconnect the I
C cable connector at the 20-pin PLANAR connector on the system
1
board.
Do not disconnect the end that is connected to the SCSI backplane.
In the customer kit, locate the I
2
20-pin connector on one end, a 10-pin connector on the other end, and a 20-pin cable
connector in the middle (see Figure 1-3).
NOTE: Figure 1-3 shows the 1 x 2 backplane and its drive cage oriented for a tower
system. For rack systems, you must install the 1 x 2 backplane and its drive cage oriented
180° from the position shown in Figure 1-3.
F i g u r e 1 - 3 . I n s t a l l i n g t h e
2
10-pin I
C connector
2
20-pin I
C connector
on system board
Cable
2
C extension cable. This cable has three connectors: a
2
I
C
E x t e n s i o n C a b l e
1 x 2 Ba ckplane Ki t Inst allat ion Gu i d e
power connector
nonterminated
SCSI cable
cooling shroud
cable clips
1-5