Dell PowerEdge 2650 Manuel d'installation - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 2650. Dell PowerEdge 2650 20 pages. Activating the integrated raid controller
Également pour Dell PowerEdge 2650 : Manuel d'installation (26 pages), Manuel d'installation (32 pages), Information Update (14 pages), Manuel d'installation (40 pages), Manuel de remplacement (28 pages), Manuel d'instructions (8 pages), Manuel (42 pages), Manuel (15 pages), Manuel (42 pages)

F i g u r e 1 - 9 .

R o u t i n g t h e P o w e r C o r d s

CAUTION: Allow some slack in each cable as you route them around hinges in the

cable-management arm.

Routing Cables

Attach the I/O cable connectors to their respective connectors on the system back

panel.

For details on cable connections, see your system's Installation and Troubleshooting

Guide and the User's Guide.

Route the power and I/O cables through the cable-management arm, using four

loosely secured tie-wraps (two in the middle and one on each end of the cable-

management arm). Do not fully tighten the tie-wraps at this time (see Figure 1-10).

Allow some cable slack in the cable-management arm to prevent damage to the cables.

Secure the cables to the cable-management arm:

After connecting the cables to the system, unscrew the thumbscrews that secure

the front of the system to the front vertical rail.

Slide the system forward to the fully extended position.

Route the cables along the cable-management arm, make any adjustments

needed to the cable slack at the hinge positions, secure the cables to the cable-

management arm with the tie-wraps, and close the wire covers over the

cable-management arm.

power receptacle housing

power cord plug

2 - Po st Ra ck I n stallation

1-15