Dell PowerEdge 4400 Manuel d'installation - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 4400. Dell PowerEdge 4400 20 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 4400 : Manuel d'installation (42 pages), Manuel d'installation (28 pages), Installation du rack (37 pages), Manuel de mise à jour (8 pages), Information Update (8 pages), Manuel de l'utilisateur (42 pages), Installation du rack (34 pages), Manuel d'installation du matériel (40 pages), Manuel d'installation (36 pages), Manuel (15 pages)

Dell PowerEdge 4400 Manuel d'installation
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
support.dell.com
5HSODFLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\
To install the replacement SEC cartridge and heat sink assembly, perform the follow-
ing steps:
1.
Remove the terminator card or old SEC cartridge from the guide bracket
assembly.
2.
Slide the SEC cartridge and heat sink assembly into the guide-bracket assembly
until the edge connector on the SEC cartridge is firmly seated in the connector on
the system board (see Figure 1-8).
3.
Place the retention clips on each end of the guide bracket in the notches on the
ends of the guide bracket, and then close the two latches to secure the SEC car-
tridge and heat sink assembly in the bracket.
4.
Replace the cooling shroud and computer cover.
guide bracket assembly
)LJXUH 5HSODFLQJ DQ 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\
DELL CONFIDENTIAL - Preliminary
heat sink
SEC cartridge
9/11/00
Microprocessor Upgrade Installation Guide
retention clips (2)
latches (2)
1-15