Dell PowerEdge 4400 Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 4400. Dell PowerEdge 4400 36 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 4400 : Manuel d'installation (42 pages), Manuel d'installation (20 pages), Manuel d'installation (28 pages), Installation du rack (37 pages), Manuel de mise à jour (8 pages), Information Update (8 pages), Manuel de l'utilisateur (42 pages), Installation du rack (34 pages), Manuel d'installation du matériel (40 pages), Manuel (15 pages)

Dell™ PowerEdge™ Systems —

Installing the External Drive Bay

This document describes how to install the external drive bay assembly in your Dell

PowerEdge system. The drive bay assembly allows up to two 1-inch hard-disk drives

to be installed in the external drive bay using hard-disk drive carriers. SCSI connectors

are built into the drive bay assembly to enable easy installation and removal of the

drive carriers. The drive bay assembly is connected to one of the SCSI controllers on

the system board.

This document applies to kits with external drive bays holding up to two 1-inch hard-

disk drives in 5U and 7U height PowerEdge systems. It does not apply to external

drive bay kits holding a single 1-inch hard-disk drive.

NOTICE: Hot-pluggable drive installation and removal is not supported for

hard-disk drives installed in the external drive bay. Removing a drive while the

system is turned on will result in a loss of data.

Before You Begin

Only trained service technicians are authorized to install hard-disk drives in the sys-

tem's external drive bay. Refer to the safety instructions at the beginning of your

Installation and Troubleshooting Guide for important information about accessing the

interior of your system.

WARNING: The power supplies in this computer system produce high volt-

ages and energy hazards, which can cause bodily harm. Only trained

service technicians are authorized to remove the computer cover and

access any of the components inside the computer, including the compo-

nents mentioned in this document for installing hard-disk drives in the

external drive bay.

WARNING: This system may have more than one power supply cable. To

reduce the risk of electrical shock, a trained service technician must discon-

nect all power supply cables before servicing the system. For more

information, refer to "Safety First—For You and Your Computer" in your

Installation and Troubleshooting Guide.

support.dell.com

Dell PowerEdge Systems — Installing the External Drive Bay

1-1