Dell PowerEdge M910 Manuel technique - Page 25

Parcourez en ligne ou téléchargez le pdf Manuel technique pour {nom_de_la_catégorie} Dell PowerEdge M910. Dell PowerEdge M910 46 pages. M-series blade servers
Également pour Dell PowerEdge M910 : Manuel de mise à jour (44 pages), Manuel de mise à jour (21 pages), Manuel de mise à jour (14 pages), Manuel d'installation (7 pages), Manuel de mise à jour (28 pages), Manuel de démarrage (12 pages), Manuel de démarrage (12 pages), Manuel du portefeuille (27 pages), Manuel technique (45 pages), Manuel de démarrage (14 pages), Manuel de démarrage (12 pages), Manuel technique (49 pages)

Imprimer la page

Dell

GT/s, and 6.4 GT/s with 11 Southbound lanes (9 data + 1 CRC + 1 spare) and 14 Northbound lanes (12

data + 1 CRC + 1 spare).

The DDR3 interface supports x4 and x8 single-rank, dual-rank, and quad-rank RDIMMs, and up to 2

RDIMMS per channel. Each DDR3 channel supports a maximum of 8 ranks. DDR3 speeds are 800 MT/s,

978 MT/s, 1066 MT/s, and 1333 MT/s. DRAM technology comes in 1 and 2Gb sizes. DIMM capacity is 2,

4, 8, 16, or 32 GB (16 GB with QR DIMMS only).

7.5 Memory RAS Support

The Intel Xeon processor 6500 and 7500 series supports high-availability memory modes including

rank and DIMM sparing as well as memory mirroring. The M910 supports rank sparing only and

mirroring as shown in Table 10.

Sparing

Type

Rules enforced

Rank

The capacity of the spare

rank must be greater

than that of any other

rank on the channel

7.5.1

Sparing

For information, see the

Dell PowerEdge Modular Systems Hardware Owner's Manual on Support.Dell.com.

7.5.2

Mirroring

For mirroring, the M910 will support two-processor/four-processor configurations with 32 DIMMs only.

When mirroring is enabled, only half of the physical memory will be visible to the system software. A

full copy of the memory is maintained, and in the event of an uncorrectable error, the system will

switch over to the mirrored copy. In two-processor (2P) mode, the mirroring will be inter-node with

hemisphere mode enabled. In this case, the memory controller (MBox) of CPU1 is mapped to the

corresponding MBox of CPU2.

For 4-processor (4P) configurations, the PowerEdge M910 also supports mirroring in the

inter-socket mode (intra-socket is not possible in 4P because each processor has only one MBox

connected to memory buffers). In this 4P case, the memory on CPU1 is mirrored with memory on

CPU3, while memory on CPU2 is mirrored with memory on CPU4.

7.6 Supported Memory Configurations

See the System Memory section in the Installing System Components chapter in the Dell PowerEdge

M910 Systems Hardware Owner's Manual on Support.Dell.com.

PowerEdge M910 Technical Guide

Table 10.

Sparing and Mirroring Support

Mirroring

No support

System Memory

section in the Installing Blade Components chapter of the

Inter-socket

Inter-

(hemisphere

socket

mode

enabled)

Rules Enforced

32 DIMM only,

Mirrored must match