2xWireless 2X Manuel d'utilisation et d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} 2xWireless 2X. 2xWireless 2X 12 pages. Gen6 cpe

Imprimer la page

7. Insert the cable through rubber grommet and terminate the cable end. The cabling for

installation is standard EIA/TIA 586B. For reference, the wiring diagram is included below the

programming information.

8. Insert the cable end into the CPE. The tab on the end should click when properly seated in the

radio unit. Confirm the end is securely seated in the radio unit. Slide the rubber grommet into

the cable entry point. It will fit snugly and recess into the case approximately ½ the thickness of

the grommet.

9. Complete the wire run to the entry point of the building and install the surge suppressor per the

instructions supplied with the surge device.

10. Connect the power cord with the power supply and insert it into a surge protected outlet or

uninterruptible power supply (UPS). Connect the cable leading from the surge device to the

power supply port marked 'POE'. Connect the port labeled 'LAN' to a computer for

programming with a standard patch cable. CAUTION: connecting any device other than the CPE

to the POE port may cause damage.

11. When correctly installed and powered up the CPE will issue DHCP addresses in the

192.168.100.x subnet.

CPE Login Instructions

1. Access the web interface via the default address:

2. At the log in prompt, enter the default username: admin and password: 2xw as shown below.

3. Choose the desired mode for the CPE to operate in. 'Bridge' mode will pass the network without

any routing required.

4. click the choose button.

5. You will then be able to set your network information, which his self-explanatory, including site-

surveys.

https://192.168.100.1:8000