Dell Wyse Z90SW Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell Wyse Z90SW. Dell Wyse Z90SW 18 pages. Z class cloud clients
Également pour Dell Wyse Z90SW : Manuel d'installation (24 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (8 pages), Manuel de démarrage rapide (8 pages), Manuel de démarrage rapide (8 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (8 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (6 pages)

Installing Z Class Flash

7. Remove the existing flash module. Locate the flash module and use the Phillips

Screwdriver to remove its retaining screw as shown in Figure 5. Lift the flash module

out of the socket.

Figure 5 Removing the existing flash module

8. Install the new flash module in the reverse order of removing the original flash

module. Carefully screw down its retaining screw until it is secure.

9. (a) Align the cover screw tabs with screw holes and press downward; (b) slide cover

toward the front of the thin client, as shown in Figure 6.

Figure 6 Reattaching the cover

10., Attach the screws in the reverse order as described in step 3.

11. Connect the power cord and power adapter, attach any other cables to the thin

client, and then attach the vertical foot.

CAUTION: Do not turn on the thin client. The thin client is ready to re-image,

however the flash module does not contain an operating system. Turning on power

to your thin client without firmware will display the error message "NO OPERATING

SYSTEM FOUND."

12.Continue with "Installing WES7p Firmware."