Dell PowerVault 110T SDLT320 Manuel de l'utilisateur - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dell PowerVault 110T SDLT320. Dell PowerVault 110T SDLT320 44 pages. User manual
Également pour Dell PowerVault 110T SDLT320 : Manuel de l'utilisateur (23 pages)
Imprimer la page
Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay. A "generic" host system with several unused bays is shown in
Figure
5. If your
system does not require mounting hardware, check that the holes in the system's chassis are aligned with the holes in the side of the tape drive.
Do not fully secure the drive yet; you may have to move it to connect the power and SCSI cables.
Step 6: Attach Power and SCSI Cables
Figure 6. Power and SCSI Cable Connectors
A red dot in the illustration denotes Pin 1 on the jumper block or connector.
Attach a spare power cable from the computer system's internal power supply to the power connector, as shown in
Figure
6, upper left. Attach a spare SCSI connector on the
system's SCSI ribbon cable to the SCSI connector, as shown in
Figure
7. (The location of the SCSI connector on the back of the drive is shown in
Figure
6, lower right.)
Figure 7. Attach the SCSI Connector