Dell PowerVault DR4100 Manuel de bonnes pratiques - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de bonnes pratiques pour {nom_de_la_catégorie} Dell PowerVault DR4100. Dell PowerVault DR4100 41 pages. Backup and recovery appliance
Également pour Dell PowerVault DR4100 : Manuel de démarrage (10 pages), Manuel (37 pages), Note de mise à jour (16 pages), Manuel (12 pages), Manuel (24 pages), Manuel (23 pages), Mise en place de Qiuck (1 pages), Manuel (27 pages), Manuel (25 pages)

Imprimer la page

Dell PowerVault DR4100 Manuel de bonnes pratiques

6.2

Network Interface Card Bonding

Network interface card (NIC) bonding provides additional throughput and/or failover functionality in the event a link is

lost. The DR4100 supports two bonding modes: dynamic link aggregation and adaptive load balancing (802.3ad and

ALB). Each of these modes has their own advantages and disadvantages that should be considered before choosing a

mode.

Dynamic link aggregation (Mode 4 or 802.3ad) creates aggregation groups that utilize the same speed and duplex (i.e.

10GB and 10GB full-duplex links). Mode 4 (See Figure 1) is highly beneficial in increasing speed and bandwidth

capability for multiple data streams, but will not increase the speed or bandwidth capability of a single data stream.

Slave selection for outgoing traffic is executed according to a simple XOR policy. When utilizing mode 4 it is important

to note that the maximum bandwidth available is not always equal to the sum of each link in the bond. Also, always

ensure that the switch(s) being used support 802.3ad Dynamic link.

Figure 1

Adaptive load balancing (Mode 6 or ALB), the default load balancing mode, is transmit load balancing with the addition

of receive load balancing (See figure 2). The receive load balancing uses address resolution protocol (ARP) to intercept

packets and reassign destination MAC addresses. This means that traffic is distributed across slave NICs according to

current load. In this mode, it is not possible to mix interfaces of different speeds. (i.e. 10GB and 1GB links) and no

specialized switch support is required. When utilizing mode 6, the total available bandwidth of the bond is equal to the

bandwidth of a single physical connection.

DR4100 Best Practice Guide | April 2014

Dynamic link aggregation