Error
Issue
Code
14949
CLI expansion license was
showing up as "In Use: No"
even though the expansion
license was installed.
14897
OST limiter throughput
below the set value.
14889
Add the option to the CLI to
show if the SNMP Trap's
email is on or off.
14845
system --upgrade fails with
error message "Upgrade
image not found".
14724
Replication speed limits not
throttling as expected.
13537
DR4100 system enclosure
hot add fails in Release 2.0.
Description
•
--tcp_dump— Collect tcp
dump report.
The auto_diags option is hidden since
this is a very special use case.
Corrected the CLI command system --
show --license –verbose to
display the license in the correct state.
The throttling speed limits that can be set
using the DR Series system CLI
commands (replication --limit
--speed) would not match the set
replication bandwidth limits.
Added additional option to alerts --
show –email command.
Email SNMP Trap's : Yes or
No
After replacing a hardware CRU or FRU,
the DR may come up in support mode with
a request to upgrade the hardware.
The throttling speed limits that can be set
using the DR Series system CLI
commands (replication --limit
--speed) would not match the set
replication bandwidth limits.
Attempting to perform a "hot add" of an
external expansion shelf enclosure in a
DR4000 or DR4100 system fails because
this is not a supported method of
operation in the 2.0 product release. To
prevent this error/failure condition from
occurring, observe the following best
practice:
Workaround/Solution
[--logs] [--cores]
[--tcp_dump] [--all]
[root@swsys-221 ~]#
system --show --
license --verbose
Feature ID: 3
Description: 27TB
Status: Enabled
Entitlement ID:
Start Date:
End Date:
Is Eval: No
In Use: Yes
Corrected some minor issues with
the OST limits to correct this issue.
Added additional option to
alerts --show –email
command to show status of Trap's
e-mail.
The GUI and CLI now place the
uploaded SW package into the
same directory so upon HW
replacement this same image can
be utilized to upgrade the new
component when necessary with
no special user action required.
Corrected some minor issues with
the replication limits to correct this
issue.
The workaround is to observe the
following best practice for
connecting an external expansion
shelf enclosure to a Release 2.0
DR4000 or DR4100 system:
•
Power off the DR4000 or
DR4100 system (this is a
requirement for 2.0 with
Dell OpenManage 7.1).
13
Imprimer la page