Dell PowerVault MD2460 Manuel du propriétaire - Page 23

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dell PowerVault MD2460. Dell PowerVault MD2460 47 pages. Direct-attach storage for poweredge servers

Imprimer la page

This section describes how to connect the PowerVault MD2460 enclosure to the host system and to the power source.

Before connecting the cables, ensure that all modules are firmly seated in their correct slots.

Topics:

•

Connect the enclosure to the host system

•

Cabling the enclosure

•

Connect the power cables

•

Verify connections

•

Configure MPIO

Connect the enclosure to the host system

To connect the enclosure to a host system:

Steps

1. Turn off the host system and all attached storage devices.

2. Connect one end of the Mini-SAS HD cable to the enclosure EMM and other end to the RAID controller or HBA on the host

system. Push the cable into the connector until it clicks into place.

NOTE:

Connectors on both ends of the SAS cable are universally keyed. You can connect either end of the cable to the

enclosure or the host system.

Figure 22. Connecting a SAS cable

1. Pull-tab

2. Mini-SAS HD cable

3. Mini-SAS HD port

3. Gently route the SAS cables through the CMAs without excess bending.

The cables on the left route through the upper CMA, and the cables on the right route through the lower CMA.

Connecting the enclosure