Dell PowerVault MD3220 Series Manuel de déploiement - Page 29

Parcourez en ligne ou téléchargez le pdf Manuel de déploiement pour {nom_de_la_catégorie} Dell PowerVault MD3220 Series. Dell PowerVault MD3220 Series 38 pages. Storage arrays
Également pour Dell PowerVault MD3220 Series : Manuel de mise à jour (32 pages), Instructions pour l'installation du rack (2 pages), Manuel de l'utilisateur (46 pages), Information Update (1 pages), Manuel technique (40 pages), Manuel de déploiement (38 pages), Manuel de déploiement (38 pages)

Post Installation Tasks

Before using the PowerVault™ MD3200 Series storage array for the first time,

complete a number of initial configuration tasks in the order shown. These

tasks are performed using the MD Storage Manager (MDSM) software.

1 For out-of-band management, you must set the network configuration for

each RAID controller module, including its Internet Protocol (IP) address,

subnetwork mask (subnet mask), and gateway.

NOTE:

You can set the network configuration using a DHCP server.

2 Start MDSM.

•

On Microsoft

ProgramsDellMD Storage ManagerModular Disk Storage

Manager Client.

•

On Linux operating systems, click the MD Storage Manager desktop

icon. You can also launch MD Storage Manager in Linux by running

the following commands at the command prompt:

/opt/dell/mdstoragesoftware/mdstoragemanager/c

lient

./SMclient

3 In the Enterprise Management Window (EMW), go to Setup Add

Storage Array and start the automatic discovery of systems.

NOTE:

Only storage arrays configured with IP address on the same subnet as

the management stations will be detected.

NOTE:

It may take several minutes for the discovery process to complete.

Closing the Automatic Discovery Status window before this stops the

discovery process.

After discovery is complete, a confirmation screen appears. Click Close to

close the screen.

Windows

operating systems, click Start

Post Installation Tasks