Dell PowerVault MD3860f Manuel de déploiement - Page 24
Parcourez en ligne ou téléchargez le pdf Manuel de déploiement pour {nom_de_la_catégorie} Dell PowerVault MD3860f. Dell PowerVault MD3860f 36 pages. Storage arrays
Imprimer la page
8.
Start MD Storage Manager and discover the array(s).
NOTE: If Dynamic Host Configuration Protocol (DHCP) is not used on the network where the
PowerVault MD storage array's management ports are connected, it is recommended that you
enable IPv6 on the management station to discover the storage array(s).
NOTE: If automatic discovery does not find the new array, use the manual option and provide
the default management ports IP addresses Controller 0 MGMT (port 0) : 192.168.128.101 or
Controller 1 MGMT (port 0): 192.168.128.102 using the same subnet or same VLAN for the MD
Storage Manager management station.
9.
If applicable, activate any premium features purchased with your storage array. If you purchased
premium features, see the printed activation card shipped with your storage array.
NOTE: The MD Storage Manager installer automatically installs the required drivers, firmware,
and operating system patches/hotfixes to operate your storage array. These drivers and
firmware are also available at dell.com/support. In addition, see the Support Matrix at dell.com/
powervaultmanuals for any additional settings and/or software required for your specific
storage array.
Console Installation
NOTE: Console installation only applies to Linux systems that are not running a graphical
environment.
The autorun script in the root of the resource media detects when there is no graphical environment
running and automatically starts the installer in a text‑based mode. This mode provides the same options
as graphical installation.
Silent Installation
Silent Installation On Windows
To run silent installation on a Windows system:
1.
Copy the custom_silent.properties file in the /windows folder of the installation media or image to a
writable location on the host server.
2.
Modify the custom_silent.properties file to reflect the features, models and installation options to be
used. Then, save the file.
3.
After the custom_silent.properties file is revised to reflect your specific installation, run the following
command to begin the silent installation:
mdss_install.exe –f <host_server_path>\ custom_silent.properties
Silent Installation On Linux
To run silent installation on a Linux system:
24