Dell PowerVault TL4000 Pour commencer - Page 30

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} Dell PowerVault TL4000. Dell PowerVault TL4000 38 pages. Tape library
Également pour Dell PowerVault TL4000 : Notes de mise à jour (3 pages), Faq (26 pages), Manuel de démarrage rapide (7 pages), Manuel du logiciel (16 pages), Manuel de configuration (22 pages), Informations importantes Manuel (10 pages), Addendum au manuel de l'utilisateur (2 pages), Manuel de démarrage (3 pages), Instructions sur les pièces jointes (17 pages), Brochure (4 pages), Manuel de l'utilisateur (20 pages)

Configuring Logs and Traces using the Web User Interface

This function is not available on the Operator Control Panel.

1. Click Logs & Traces in the left navigation pane.

2. It is recommended that you select Continuous so all information for logs and

3. Leave all options under Trace Level and Trace Filters selected. These options

4. Click Submit to apply any changes.

Figure 1-26. The Configure Library: Logs and Traces screen

Entering Event Notification Information using the Web User

Interface

This function is not available on the Operator Control Panel.

Use this menu item to set up email notification of library errors and warnings.

1. If you would like to be notified when an error occurs, select Notify Errors.

2. If you would like to be notified when a warning occurs, select Notify

3. In To Email Address, enter the email address to which the information will be

4. In Email Domain, enter the domain name for the email address.

1-20

Getting Started with the Dell PowerVault TL2000 and TL4000 Tape Libraries

Note: Path Failover is a combination of two previous features: Control Path

Failover (key entered at the library user interface) and Data Path Failover

(key entered at the device driver interface). A single activation key

entered at the library user interface now activates both features unless

the LTO-3 drive firmware level is equal to or lower than 69U2 and/or

the library firmware is equal to or lower than 1.95. For either or both of

these two cases, the device driver interface Data Path Failover key

activation will still be required. The Path Failover feature is available for

Fibre Channel and SAS type drives. Path Failover is not supported for

half high drives.

traces will be captured.

can be changed by Service personnel only.

Warnings.

sent.