Dell PowerVault TL4000 Informations importantes Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Informations importantes Manuel pour {nom_de_la_catégorie} Dell PowerVault TL4000. Dell PowerVault TL4000 10 pages. Tape library
Également pour Dell PowerVault TL4000 : Notes de mise à jour (3 pages), Pour commencer (38 pages), Faq (26 pages), Manuel de démarrage rapide (7 pages), Manuel du logiciel (16 pages), Manuel de configuration (22 pages), Addendum au manuel de l'utilisateur (2 pages), Manuel de démarrage (3 pages), Instructions sur les pièces jointes (17 pages), Brochure (4 pages), Manuel de l'utilisateur (20 pages)

Important Information—Read Prior to Using Your

Dell™ PowerVault™ TL2000/TL4000 Tape Library

This document supplements the Dell PowerVault TL2000/TL4000 User's

Guide that contains information about support, setup, and configuration of

your Dell PowerVault tape library.

TL2000/TL4000 A06 Firmware Release Changes

NOTE:

For information on new features like key path diagnostics, SSL, EKM,

manual ethernet settings, and super user account, refer to the Dell PowerVault

TL2000/TL4000 User's Guide on the Dell Support website at support.dell.com.

A06 Firmware Release Issues

The following issues may occur while using your PowerVault TL2000/TL4000

tape library:

•

Changing the library operation mode from random to sequential using

the Remote Management Unit (RMU) does not work without rebooting

the library.

It is recommended to take the library offline by removing it from the host

bus and rebooting the library for the settings to take effect.

•

Network changes require a reboot of the library.

Most network changes (changing the IP address, changing the Protocol

Stack, enabling/disabling DHCP, etc.) require a reboot of the library. In

such instances, a message saying Changes will take effect

after a reboot appears at the top and bottom of the screen. Other

changes made during this time may not require the reboot to take effect.

However, the message remains until a reboot is initiated from the remote

interface by clicking Service Library→ Reboot→ Reboot.

•

If the dual IP stack is enabled (IPv4 + IPv6), IPv6 addresses cannot be

configured in the Operator Control Panel (OCP) and must be

configured through the web interface.

IPv6 addresses can only be configured in the OCP if the IPv6-only stack is

enabled. If the dual stack is enabled, the IPv6 address must be configured

through the web interface (either using the IPv4 address or another known

IPv6 address).

Important Information