Dell C Series Manuel de démarrage rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dell C Series. Dell C Series 27 pages. Systems
Également pour Dell C Series : Manuel de l'utilisateur (2 pages)
Imprimer la page
Installing the Hardware
This guide assumes all site preparation has been performed before installing the
chassis.
Installing the Chassis
To install the C7004/C150 and the C7008/C300 chassis, Dell Networking
recommends completing the installation procedures in the order presented
below.
NOTE: Unless stated otherwise, the installation instructions apply to both the
C7004/C150 and C7008/C300 chassis.
Always handle the system and its components with care. Avoid dropping the
switch or its field replaceable units (FRUs).
CAUTION: Always wear an electrostatic discharge (ESD)-preventive wrist or
heel ground strap when handling the chassis and its components. As with all
electrical devices of this type, take all necessary safety precautions to prevent
injury when installing this system. ESD damage can occur if components are
mishandled.
Installing the Chassis in a Two-Post Rack
WARNING: Use an equipment lift or pallet jack when lifting or moving the
chassis. Install the chassis into the rack before inserting chassis components.
Lift the chassis only from the bottom. Lifting by the chassis shelves or power
supply openings might damage the chassis.
WARNING: To prevent bodily injury when mounting or servicing this unit in
a rack, take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
•
Mount this unit at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the
bottom to the top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers
before mounting or servicing the unit in the rack.
Installing the Hardware
1
5