Dell Force10 S60 Series Manuel - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell Force10 S60 Series. Dell Force10 S60 Series 45 pages.
Également pour Dell Force10 S60 Series : Manuel de démarrage rapide (29 pages)
Imprimer la page
To attach the brackets to the chassis, follow these steps:
Step
Task
Take the brackets and screws out of their packaging.
1
Attach the brackets to the rear sides of the chassis using four screws for each bracket. Attach the bracket so that
2
the "ear" faces to the rear and the outside of the chassis.
Install the Chassis into the Rack or Cabinet
To permit access and airflow, ensure that there is adequate clearance surrounding the rack or within the
cabinet. When you install two S60 systems near each other, to permit proper airflow, position the two
chassis at least five inches (12.7 cm) apart.
To install a switch into a two-post 19-inch equipment rack, using the already attached mounting brackets,
follow these steps:
Step
Task
NOTE:
Dell Networking recommends one person holding the S60 chassis in place while another person
attaches the brackets to the posts.
Attach the bracket "ears" to the rack or cabinet posts using two screws for each bracket. Ensure the screws are
1
tightened firmly.
View from chassis rear
View of chassis front
Power Supply
PSU0
PSU1
Power Supply
Connect to
rack/cabinet
(ear)
Screws
Connect to
rack/cabinet
(ear)
Rack Mounting
Rack/Cabinet
"ears"
Post
Install the S60 System
|
12