3 Day Blinds METAL BLINDS Deluxe Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 3 Day Blinds METAL BLINDS Deluxe. 3 Day Blinds METAL BLINDS Deluxe 6 pages.

Imprimer la page

INSIDE MOUNT WITH END BRACKETS

NOTE: An end mount is recommended only when there is no

alternative mounting surface available.

You will be using your blind with mounting brackets attached

to the headrail to mark the position of the brackets inside

your window casing (no template required). Bolt the inside

mount brackets to each end mount bracket with the nuts and

bolts provided to create a left hand bracket and a right hand

bracket. Use appropriate holes as shown below.

• Lower the blind to its full length. (see "Blind Operation")

• Hold the blind up to the desired mounting position in the

window casing.

Attaching brackets to headrail is described in "Blind Installation".

| 1" Metal Blinds Deluxe

• For Blind width of 10

to 13" use second and

fourth holes of the end

mount bracket.

• For Blind width of 13

and over use first and

third holes of the end

mount bracket.

• Once the blind is level,

mark the wall or molding

on the top edge of each

mounting bracket.

• Remove the mounting

brackets from the headrail

by pushing the back of the

bracket forward and up

with your thumb.

For maximum stability the screws should be installed

diagonally.

Proceed to "Blind Installation".

• Recess the back of the

bracket no more than

" from the front edge

of the window casing.