Dell Networking S4810 Manuel de configuration - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Dell Networking S4810. Dell Networking S4810 17 pages. Open networking
Également pour Dell Networking S4810 : Spécifications (2 pages), Manuel de configuration (17 pages), Manuel d'installation (42 pages), Manuel de démarrage (16 pages)

Imprimer la page

Dell Networking S4810 Manuel de configuration

Configure Data Center Bridging (DCB) (Optional)

To enable DCB mode on the switch, use the following commands.

Note: You must complete the Dell recommended switch configuration steps in Sections 2.1 to 2.12

before configuring the switch for DCB mode.

3.1

Disable 802.3x flowcontrol on SFP+ ports

FTOS#configure

FTOS(conf)#interface range tengigabitethernet 0/0 - 47

FTOS(conf-if-range-te-0/0-47)#no flowcontrol rx on tx off

FTOS(conf-if-range-te-0/0-47)#exit

3.2

Disable 802.3x flowcontrol on QSFP ports

FTOS(conf)# interface range fortyGigE 0/48 , fortyGigE 0/52

FTOS(conf-if-range-fo-0/48-52)#no flowcontrol rx on tx off

FTOS(conf-if-range-fo-0/48-52)#exit

3.3

Enable DCB and reload

FTOS(conf)#dcb enable

FTOS(conf)#exit

FTOS#copy running-config startup-config

FTOS#reload

Note: The switch will reboot.

3.4

Create tagged VLAN for all ports and port-channels

FTOS#configure

FTOS(conf)#interface vlan vlan-id

Note: You must supply a VLAN id. The valid range is 2-4093.

FTOS (conf-if-vl-vlan-id*)#no shutdown

FTOS (conf-if-vl-vlan-id*)#tagged tengigabitethernet 0/0-47

FTOS (conf-if-vl-vlan-id*)#tagged port-channel 1

FTOS (conf-if-vl-vlan-id*)#exit

SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs