Allied Telesis AT-AR023 SYN Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Allied Telesis AT-AR023 SYN. Allied Telesis AT-AR023 SYN 13 pages. Port interface card
Également pour Allied Telesis AT-AR023 SYN : Manuel d'installation (13 pages), Fiche technique (1 pages), Manuel d'installation rapide (10 pages), Manuel d'installation et de sécurité (8 pages)

Package Contents

The following items are included with each Port Interface Card (PIC). Contact your

authorised Allied Telesis distributor or reseller if any items are damaged or missing.

two spring-loaded retaining thumbscrews

■

two jumpers (AT-AR020 PRI E1/TI and AT-AR021(S) BRI-S/T only).

■

this Installation and Safety Guide

■

one warranty card

■

Choosing a PIC Bay

Observe the following guidelines when selecting a PIC bay:

Use the PIC bays on the switch or router base unit first, before installing PICs

■

into an AT-AR040 NSM.

Fill the PIC bays in an AT-AR040 NSM starting at bay 0.

■

You can install a maximum of two AT-AR020 PRI E1/T1 PICs into an AT-AR040

■

NSM, and maximum of four total in a switch or router.

If two AT-AR020 PICs are installed in an AT-AR040 NSM, PIC one must be

■

installed in the lower row (bay 0 or 1) and the other PIC must be installed in the

upper row (bay 2 or 3).

If an AT-AR020 PIC is installed in an AT-AR040 NSM, and operating in E1 mode,

■

you can not install an AT-AR021(S) or AT-AR021(U) PIC in the same row of the

NSM.

You can install a maximum of four AT-AR027 PICs in an AR745 router fitted with

■

an AT-AR040 NSM.

Avoid installing an AT-AR022 or AT-AR026 PIC in an AT-AR040 NSM.

■

Performance of these interfaces may be reduced and packet loss may occur.

For instructions on installing an AT-AR040 NSM into your switch or router, see the

Network Service Module Installation and Safety Guide supplied with the NSM. You can

also download this document from www.alliedtelesis.com/support/software.

Port Interface Card