Dell PowerConnect 6224 Note de mise à jour - Page 24
Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} Dell PowerConnect 6224. Dell PowerConnect 6224 34 pages. Powerconnect 6200 series
Également pour Dell PowerConnect 6224 : Spécifications (2 pages), Manuel de planification et de préparation (12 pages)
Imprimer la page
Title
show ip ospf neighbor
Port Configuration Show Command
Title
show interfaces detail {ethernet interface | port-
channel port-channel-number}
Custom Protocol Based VLANs
Title
vlan protocol group add protocol <groupid>
ethertype <value>
no vlan protocol group add protocol <groupid>
ethertype <value>
vlan protocol group <groupid>
no vlan protocol group <groupid>
vlan
protocol
group
<groupName>
no vlan protocol group name <groupid>
VLAN Name Support with RADIUS Server
Title
show dot1x Ethernet interface
22
Description
This command has been enhanced to list the per neighbor graceful restart
status described in the RFC 4750 MIB. Possible values for Restart Helper
Status are as follows:
• Helping – This router is acting as a helpful neighbor to this neighbor.
• Not Helping – This router is not a helpful neighbor at this time.
Description
A new single command that shows VLAN, STP, Port status, and Port
Configuration information.
Default: Not applicable
Description
Previously only ARP, IP and IPX are configurable as protocols for
protocol-based VLANs. This has been extended so that any Ethertype
may be used.
•
•
Default: Not applicable
If the user creates multiple vlan protocol groups, deletes one of them, and
then saves the configuration, the older implementation of this command
resulted incorrectly applying the groupids on reload. Hence, the existing
command vlan protocol group <groupname> is updated to vlan
protocol group <groupid> so that groupid is used for both configuration
and script generation.
•
Default: Not applicable
name
<groupid>
This is a new command for assigning a group name to vlan protocol group
id.
•
•
Default: Not applicable
Description
The command was updated to display the VLAN Id, or name as required.
Default: Not applicable
groupid—The
protocol-based
automatically generated when you create a protocol-based VLAN
group with the vlan protocol group command. To see the group
ID associated with the name of a protocol group, use the show
port protocol all command.
ethertype—The protocol you want to add. The ethertype can be
any valid hexadecimal number in the range 1536 to 65535.
groupid—The protocol-based VLAN group ID, to create a protocol-
based VLAN group. To see the created protocol groups, use the
show port protocol all command.
groupid—The
protocol-based
automatically generated when you create a protocol-based VLAN
group with the vlan protocol group command. To see the group
ID associated with the name of a protocol group, use the show
port protocol all command
groupName—The group name you want to add. The group name
can be up to 16 characters length. It can be any valid alpha
numeric characters.
System Firmware Version 3.2.0.6
VLAN
group
ID,
which
VLAN
group
ID,
which
is
is