Dell PowerConnect M8024 Manuel de configuration - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Dell PowerConnect M8024. Dell PowerConnect M8024 21 pages. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Également pour Dell PowerConnect M8024 : Note de mise à jour (9 pages), Notes de mise à jour (27 pages), Mise à jour du micrologiciel (24 pages)
Imprimer la page
4
Optional virtual stack configuration for 8024 and 8024F
Note: If you wish to use a virtual stack configuration instead of LAG, follow the instruction below instead
of section 2 or 3.
One advantage of stacked switches is that they can be managed as a single switch; however firmware
updates will update all members of the stack simultaneously and therefore should only be done during
planned downtime.
Do not connect the cables between the stacked switches (this will be done in a later step).
On both switches, enter the following commands:
4.1
Check firmware version
console>enable
console#show version
Note: If the active version displayed is not 5.1.1.7 or later, please visit support.dell.com and download the
latest update for your switches.
4.2
Delete startup configuration
Note: All configuration settings will be deleted
console#clear config
console>enable
console#copy running-config startup-config
console#reload
Are you sure you want to reload the stack? (y/n) y
Note: The switch will reboot.
On the first switch only, proceed with the following steps:
15
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs