Dell PowerEdge 350 Manuel d'installation - Page 23
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 350. Dell PowerEdge 350 32 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 350 : Mise à jour des informations de diagnostic du système (2 pages), Information Update (30 pages), Installation du matériel (22 pages), Manuel (15 pages)
Imprimer la page
support.dell.com
3.
Remove the front door from the rack as shown in Figure 1-14.
a.
With the door open, lift out and fully retract all hinge pins.
b.
Once all the hinge pins have been lifted out and retracted, lift the door out.
hinge insert
Figure 1-14. Removing the 24-U Rack Doors
CAUTION: Store the two doors where they will not injure someone if the
doors accidently fall over.
If you want to reverse the door so that the handle is on the other side, perform the
following steps:
1.
With the door open, lift out and fully retract all hinge pins.
2.
Remove the hinges and door brackets from the door frame.
3.
Replace the hinges and door brackets on the opposite side and switch the posi-
tion of the handle.
4.
Replace the rack door (see the section, "Replacing the Rack Doors," found later
in this guide).
Installing the Slide Assemblies in the Four-Post Rack
NOTE: If the slide assemblies were preinstalled by Dell, you can skip this section.
hinge pin
hinge
Rack Installation Guide
1-17