Dell PowerEdge 500 Manuel - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell PowerEdge 500. Dell PowerEdge 500 15 pages. Wake-on-lan (wol) support on dell servers

Imprimer la page

6. Restart the server. After the server has restarted, if the NIC is not already

connected to a switch or hub, connect it and shut the server down.

7. Shut the system off. The connection LED on the NIC and switch or hub will

remain on indicating the NIC is monitoring the network for wake up packets

directed to its MAC address.

8. Send a wake up signal to the MAC address of the WOL enabled NIC, and the

system will boot.

Note: If the system boot is interrupted before the OS and the NIC driver are loaded, the

system will not be able to perform WOL again until the system is rebooted manually and

the OS and driver are allowed to load and reset the NIC's WOL registers.

without the express written permission of Dell Computer Corporation is strictly forbidden. For more information, contact

Dell. Dell cannot be responsible for errors in typography or photography.

Trademarks used in this text: Dell, PowerEdge, and OpenManage are trademarks of Dell, Inc.; Microsoft, Windows, Windows

NT, and Windows Server are registered trademarks of Microsoft; Intel is a registered trademark of Intel Corporation.; Red

Hat and Red Hat Enterprise Linux are registered trademarks of Red Hat, Inc.; Novell and NetWare are registered trademarks

of Novell, Inc.; SUSE is a registered trademark of SUSE Linux Products GmbH. Other trademarks and trade names may

be used in this document to refer to either the entities claiming the marks and names or their products. Dell disclaims any

proprietary interest in trademarks and trade names other than its own.

Information in this document is subject to change without notice. The content is provided as is, without express or

implied warranties of any kind.

October 2007

Page 15

Dell Enterprise Product Group