Allied Telesis AR740 RPS Manuel d'installation rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allied Telesis AR740 RPS. Allied Telesis AR740 RPS 6 pages. Ar700 series router
Également pour Allied Telesis AR740 RPS : Manuel d'installation rapide (13 pages)
Imprimer la page
Quick Install Guide
Figure 1: Front and rear panels of the AT-RPS 740
Front panel
Rear panel
AC POWER 1
AC Power
100-240 VAC
50-60Hz
1.5A
C613-04025-01 REV F
5.
Place the RPS in its operating location.
See the previous "Selecting a Site" section for guidelines on choosing a
suitable location.
If installing the RPS on a desktop:
•
Make sure the RPS's rubber feet are attached.
If installing the RPS in a rack:
•
Remove the rubber feet.
•
Attach the rack-mounting brackets.
•
Mount the RPS in the rack.
6.
Connect the DC cable(s).
Using the DC cables that were included with your RPS, connect each cable
to a router and then to the RPS.
7.
Connect the AC power cord(s).
Using the supplied AC power cord(s), connect the RPS to a power outlet
and then switch the power switch(es) to the ON position.
RPS DC OUTPUT 1
RPS
AC Power
On
5V/6.5A
1
12V/1.0A
-12V/0.2A
2
DC power outlets
supply switches
8.
Check the RPS LEDs.
Check the RPS LEDs to verify that the RPS is operating correctly. Note that
the RPS effectively consists of two RPS supply units, and each unit has its
own set of LEDs.
ROUTER
RPS DC OUTPUT 2
RPS Fan
Main PSU
RPS PSU
Main Fan
Fault
Fault
Fault
Fault
LEDs
(DB25s)
AC power
supply inlets
AC power
AC POWER 2
AC Power
100-240 VAC
50-60Hz
5V/6.5A
1.5A
12V/1.0A
-12V/0.2A
5