Dell PowerEdge M520 Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell PowerEdge M520. Dell PowerEdge M520 25 pages. Dell poweredge blade servers getting started guide
Également pour Dell PowerEdge M520 : Information Update (38 pages), Notes de mise à jour (27 pages), Manuel de l'utilisateur (23 pages), Informations importantes Manuel (35 pages), Manuel de mise à jour (32 pages), Manuel de mise à jour (28 pages), Manuel de l'utilisateur (26 pages), Manuel de l'utilisateur (22 pages), Manuel de démarrage (12 pages), Manuel technique (46 pages), Manuel technique (45 pages), Manuel du portefeuille (27 pages), Manuel de démarrage (14 pages), Manuel de démarrage (12 pages)

About this Manual

This manual describes the installation and basic use of the Dell 10Gb Ethernet Pass Through -k

for M1000e.

This manual is intended for users and system administrators responsible for installing and setting

up the I/O module.

Table 2 - Abbreviations and Convention

Term

IOM

PTM

Downlink

Uplink

SSH

CMC

Component

Component numbering

http://support.dell.com/support/

Definition

I/O Module

Pass Through Module

Internal link – from servers to 10GbE PTM PHY (through the mid plane connector)

External link – from 10GbE PTM PHY to external link (typically connected to Ethernet switch)

Secure Shell (also refers to a software program that allows connectivity using an SSH protocol.)

Chassis Management Controller

10GbE PTM PHY device

Components are numbered from one (1) to three (3).

When looking at the 10GbE PTM component side with external connectors (uplink) up, the compo-

nents are numbered as follows:

Device number 1 is the right-most component

Device number 2 is the middle component

Device number 3 is the left-most component

Wherever applicable, device number 0 refers to the on-board micro-controller

Rev 1.00